Features of tin-bath hardening for small parts

Автор(и)

  • E. S. Skorbyaschensky Oles Honchar Dnipro National University, Dnipro, Ukraine
  • V. F. Bashev Oles Honchar Dnipro National University, Dnipro, Ukraine
  • A. N. Polishko Oles Honchar Dnipro National University, Dnipro, Ukraine
  • S. N. Antropov Oles Honchar Dnipro National University, Dnipro, Ukraine

DOI:

https://doi.org/10.15421/331923

Ключові слова:

martensite, sorbitol, trostite, bainite, heat exchange, hardness, cooling rate, microcracks, hardening, hardening check, quencher, steam jacket, low-melting alloys

Анотація

The method of quenching in tin melt was tested for low-weight parts with a large specific surface, made of a number of steels with a high temperature of the onset of martensitic transformation. The advantages of this method in comparison with traditional hardening technologies are established, as well as regularities in the change of cooling curves for various mass ratios of the part and the quencher are revealed. The practical possibility of adjusting the cooling rates in the process of hardening in various temperature ranges in order to optimize the phase ratio in steel while maintaining the possibility of preventing the occurrence of microcracks is shown.

##submission.downloads##

Опубліковано

2019-12-27

Номер

Том 27 № 2 (2019)

Розділ

Articles